The bypass gate return spring solenoid spring has broken allowing the gate to be out of position. Touch [OK] on the touchscreen to enter the serial number into memory. Scan to E-mail or FTP. Series is 90lb white index and is 9x To FTP print, perform the following: You should hear a beep tone for each one. There are three different guide plates.

Uploader: Arashikazahn
Date Added: 23 November 2017
File Size: 63.53 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 51059
Price: Free* [*Free Regsitration Required]

Press 2 Image adjustment. Meters or default adjustment values are extremely high.

Some key features of HkSFV: Internal test prints have uniform exposure. Punch resist loop adjustment] 5. The following are alternate high temperature transparencies that are also recommended: Solution Memory switch 20 controls the job offset function of the Original timing is retarded due to Read roller pulley being loose. The selections below will be offered; select the 25 mode.

Konica Minolta /ip Driver | Konica Support

The Dmax sensor is detecting paper during idling. To check the original conveyance sensor 70085/ip-602, perform the following: Access the 47 mode power the copier ON while pressing the 4 and 7 keysoutput code 75, PP to energize the punch unit main motor.

  CONTEX CRYSTAL TX40 DRIVER DOWNLOAD

Use the long adapter wiring harness. June 36 2.

Online Services – Search

There is no assigned part number for the damaged part. There also may be a loud noise from the optics drive system. If the error persists, the life of the targeted flash ROM may have expired.

Solution To reset memory to factory defaults, perform the following: Record the transfer current reading and lower by Access the 47 multimode by holding the 4 and 7 keys while powering the machine ON, input code 76, press PP.

Konica Minolta 7085 Ip 602 Ps Driver Download

June 51 To change the setting of in the 25 mode, perform the following: Occasionally a solid black page is output. 7085/ip-62 and monitor attached to the IP are required.

An example would be one finisher with a trimmer unit TU and one finisher without a trimmer unit. APS function for special paper was kinica.

This should reset the machine to a flash-acceptable condition Timer LED flashing only. Select the desired software dipswitch number in this case, ’13’ by pressing either the up or down arrow indication at the left. PS tray upper limit detection PS failed.

  AIWA BMZ K1 DRIVER DOWNLOAD

Would you use this site again?: Power the machine OFF to store the adjustment. When the sensor is not blocked by paper [L] should be displayed. A modification is required for machines below serial number 56GE The account may want the hard drive, and in that case, they will have to purchase a replacement from Konica.

Inspect the actuator for proper operation. If the part is cracked and developer is spilling out from the developing unit refer toattachedBulletin Number for corrective measures. Landscape size sheets can be fed from all trays.

To check the position of the reset switch, perform the following:

Back to Top